4.1. precautionary measures
This machine may only be used with foodstuffs. It cannot be used for heating liquids or grinding any other kind of product that could damage and pollute it.
The manufacturer cannot be held responsible for damage to people or things caused by unsuitable, erroneous or irrational use.
5. TRANSPORT
5.1. Packaging
The machine is delivered in a strong cardboard box with internal protection.
The packaging bears symbols which must be obser- ved during handling and stocking of the item.
Always keep the package in a vertical position during transport. Do not turn it over or lay it on its side and avoid bumping and exposure to atmospheric agents.
5.2. Inspection on receipt
Check that the machine received corresponds to the one indicated on the delivery note, including any accessories.
Check that it has not been damaged during transport and, if so, inform the forwarder and our customer service office immediately.
The packing elements (plastic bags, expan- ded polystyrene, nails, cardboard, etc.) must not be left within reach of children as they are potential sources of danger. Do not dispose of the packing elements in the environment; consign them to firms authorized for their disposal.
6. INSTALLATION
The appliance is only to be installed in locations where use and maintenance is restricted to trained personnel.
The machines are fitted with height adjustable feet (only rear).
The support surface shall be levelled, dry, smooth, steady and stable and at such a height that the cup- warming surface is at over 150 cm from ground. Do not use water jets or install where water jets are used.
In order to guarantee normal operation, the machine must be installed in areas that the environmental temperature is between +5°C ⎟ +32°C end humidity of not over 70%.
It does not need to be anchored to the surface and it does not require any technical operations to dampen vibrations in order to operate properly.
It is recommended to leave the area around the ma- chine free to facilitate its use and the performance of any maintenance operations.
If the machine is wet or very damp, wait until it is completely dry before installing or using it. It is always necessary to request an accurate control to qualified service people in order to find any possible damage to the electric components.
Reserve an area near the machine for the installa- tion of the coffee grinding and dosage machine (see relevant documentation).
The machine is usually equipped with a water sof- tener, type DP2 or DP4, which must be connected by the user in compliance with the laws in force. Should a different softener be installed, refer to the documentation of the relevant product.
A dreg drawer should be fitted by the installer.
6.1.Connections to be made by the user.
6.1.1. Water supply (Mod.E1 - S1) (Fig.5)
This equipment is to be installed to comply with the applicable federal, state
or local plumbing codes.
Connections must be installed close to the machine.
●Water drainage pipe 1, having a minimum internal diameter of 30 mm, equipped with a
●Water supply pipe 2, with a 3/8"G
Make sure that the maximum supply pressure does not exceed 6.5 bar; otherwise, install a pressure reducer.
50
