Rancilio S1 TANK manual Maintenance, Models E1, Adjusting the dose, Model S1 Tank

9.ADJUSTMENT AND SETTING OF THE DOSE (where available)

9.1. Models E1

It is possible to adjust the dose of coffee dispensed E1 models.

9.1.1. Adjusting the dose

The coffee dose adjustments are made by acting on the group keyboads with machine at rated pres- sure.

1Press the button E on the panel and hold it down for 8-10 seconds until water stops flowing from the dispensing unit and the led of the continuons button begins flashing.

2It is necessary to act as to make 1 or 2 cups in or- der to reach the correct coffee amount adjustment in the cup.

3Put the filter-holder (with ground coffee) on the left unit and the cup under the spout.

4Operate the selected button (i.e. button A for one small cup).

5One the required coffee amount in the cup has been reached, press the stop button E. Coffe will stop pouring and the microprocessor will store the dose.

6Press the continuous button E again; the led will go out and the machine will store the new quantity.

7Make the coffee and check the cup amount in order to check that programming is correct.

If some doses have to be changed (B-C-D), once at point 5 repeat the instructions in points 3-4-5 for each dose, remembering to use the filter-holder with relevant filter and freshly ground coffee.

Then carry out point 6 and repeat point 7 to check all changed doses.

10. MAINTENANCE

Maintenance operations have to be carried out when the machine is off and cold and the plug is disconnected. Some particular

operations have to be effected when the machine is operating.

Do not clean the machine by using metal or abrasive devices, such as steel wool, metal brushes, needles, etc. or general detergents (alcohol, solvents, etc.)

When necessary, use special detergents for coffee machines that can be bought in spe- cialized service centres.

10.1.Daily (Fig.9)

Use a clean cloth or sponge that does not leave hairs or fluff (preferably cotton or linen).

●Carefully clean the outside surface, following the grain of the satin finish on the parts in stainless steel.

●Clean the steam and hot water spouts, check that the nozzles are not encrusted (if they become encrusted, be careful not to deform or damage them).

●Clean the spray units and the seals under the ca- sing of the delivery units using the special brush supplied

●Remove the filter-holders of the machine and re- move the filters and the clamp which secures the filter, use a brush to remove any coffee deposits and rinse with hot water in order to dissolve any grease deposits.

Model S1 TANK

Operation to be carried out when the ma- chine is off and cold and the plug is discon- nected.

●Remove the lid on the water-tank;

●Remove the air trap C and softener A (Fig.7);

●Take out the water-tank, empty and clean it;

●Thoroughly rinse the water-tank and replace it in the machine;

●Place the air trap in its guide and the softener horizontally on the bottom of the water-tank;

●Fill the tank with clean water and close the lid.

If the air trap is not in the correct position, the machine cannot heat or indicate a lack of water in the tank.

54