Rangemaster RDW459FI/SF manual Using 3-in 1 Detergent Tablets, Switching the dishwasher OFF

Switching the dishwasher OFF

Several minutes after the programme has ended:

1.Open the door.

2.Set the ON-OFF button to OFF.

3.Remove dishes, etc. when they have cooled down.

Note: For the best drying performance, we recommend that you do not remove the contents for at least 30 minutes. This allows residual heat in the dishwasher to remove any small droplets of water that may occur.

Interrupting the programme

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case the detergent dispenser must be refilled; see ‘Loading the detergent’.

To cancel a programme that is underway, carefully open the door and press the programme button and hold it in for about 3 seconds.

CAUTION!

nn

There is a risk of water coming out from inside the appliance. DO NOT open the door fully until the spray arm has stopped rotating.

When you open the door, the dishwasher will beep ten times every thirty seconds.

If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close.

After 30 seconds the programme will start from the point it was interrupted.

Cancelling or modifying a cycle

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see ‘Loading the detergent’).

To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled ‘Reset drain function’ and select the programme you wish (see ‘Switching the dishwasher ON’).

Using 3-in 1 Detergent Tablets

General Advice

1.Before using these products you should first check that the water hardness in your supply is compatible with their use, as per the detergent manufacturers instructions (on the product packaging).

2.These products should be strictly used according to the detergent manufacturers instructions.

3.If you encounter problems when using 3-in-1 products for the first time then please contact the detergent manufacturers care line (the telephone number is given on the product packaging).

Special Advice

When using combination products, the rinse-aid and salt lights are no longer useful.

It may be helpful to select the lowest possible setting for water hardness.

9