Electrical Connection
The dishwasher must be installed by a qualified electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations.
nnWARNING: THIS APPLIANCE MUST BE EARTHED
All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. Connection to the electrical supply can be made with either a plug and socket or be permanently wired via a double pole switch. The dishwasher is supplied with a
Should the plug not fit the socket in your home, it should be removed and replaced with a suitable plug.
Note: If the plug is fitted is not suitable, it must be cut off and disposed of properly. To avoid the risk of electrocution, the plug must not be left where children might find it and plug it into a supply socket.
Three pin plugs to BS 1363 with a capacity of not less than 13 A must be used and fitted with a 13 amp fuse ‘ASTA’ approved to BS 1362.
After replacing the fuse the cover must be refitted. If the cover is lost, the plug must not be used until a replacement cover has been obtained from your supplier. The colour of the correct fuse carrier is that of the coloured insert in the base of the fuse recess, or stated elsewhere on the plug. Always state this colour when ordering a replacement fuse carrier.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: EARTH
Blue:NEUTRAL
Brown:LIvE
CAUTION
nn
The dishwasher plug must be accessible even when the appliance is installed as a
Care for the external cable
•Hold the plug, not the electrical cable, when unplugging the dishwasher.
•Make sure that the dishwasher does not trap the electric cable.
•Do not step on the cable.
•Avoid damage to the electric cable when moving the dishwasher.
Damaged electrical cable
If the electrical cable is damaged or worn, switch off the dishwasher and consult an authorized agent for replacement.
Levelling the Dishwasher
When the unit is in position, adjust the feet to level the dishwasher. In any circumstance, the dishwasher should not be inclined more than 2° otherwise the performance may be affected.
Fig.5-5
870 mm max
Adjustable feet
Plastic skid
RDW6015
Wooden spacer
Fig.5-6
A
B
Fig.5-7
A
B
17
