Checking the parts | Rangemaster U109600-02 specs

You will need the following equipment to complete the cooker installation satisfactorily

STABILITY BRACKET

If the cooker is to be supplied with gas through a ﬂexible hose, a stability bracket or chain must be ﬁtted.

These are not supplied by with the cooker but are available at most builders’ merchants.

GAS PRESSURE TESTER

FLEXIBLE GAS HOSE

Must be in accordance with the relevant standards.

MULTIMETER

(for electrical checks)

You will also need the following tools:

1.Electric drill

2.Masonry drill bit

(only required if fitting the cooker on a stone or concrete floor)

3.Rawlplugs

(only required if fitting the cooker on a stone or concrete floor)

4.Screws for fitting stability bracket

5.Pencil

6.Steel tape measure

7.Cross head screwdriver

8.Flat head screwdriver

9.4mm & 3mm Allen keys

10.Spirit level

11.Adjustable spanner

Checking the parts

	4 pan supports	Griddle plate
	Grill pan and trivet	Levelling tool
	Handyrack	Meat tin
	ArtNo.324-0011 Flat & drop shelves
	2 ﬂat oven shelves and 2 drop	Splashback & Plinth
	shelves.	Splashback & Plinth
	shelves.
	Conversion kit from Natural	Hand rail and door handles
	gas to LP gas	Hand rail and door handles
	gas to LP gas

28

Image 28

Rangemaster U109600-02 manual Checking the parts, You will also need the following tools

Contents

Dual Fuel Installation This appliance should not be installed in a boat or caravanBe safe Gas and Electricity on Contents Hotplate Burners High/medium GriddleMedium/low Wok cradle Care and CleaningEssential information Never close the grill door when the grill is on Using the grillGlide-out Grill Ovens Left Hand Oven Right Hand Fan Oven Setting the time of day To stop the beeper when it soundsClock To time something that’s cooking minute minder Auto is showing, you want to reset to manual cooking Clock Special Features Key LockTo start & stop the oven automatically To activate the key lock Cooking using the timer Both Ovens Multi-function oven Multi-function oven functions Handyrack Conventional oven top and base heat Oven shelves Oven light Storage Cooking chart Fan assisted oven function Multi-function Oven cooking guideEnsure meat and poultry is fully cooked before serving Food Oven Cooking chart Conventional and full Fan oven functions Fish Cleaning your cooker Hotplate burnersCentral hotplate Wok burners Griddle Glide-out Grill Cleaning Table Hotplate Part Finish Recommended Cleaning MethodOutside of cooker Oven and Grill Control Panel and Doors OvensRemoving the Oven Linings Do not put the side runners in a dishwasher Moving your cooker To refit the draw Troubleshooting Oven temperature getting hotter as the cooker gets older Hotplate ignition or hotplate burners faultyGrill not cooking properly Oven light is not working General Safety Instructions 0800 111 This appliance is heavy, take care when moving it Installation Dear InstallerProvision of Ventilation Location of Cooker Checking the parts You will also need the following tools Unpacking the Cooker Positioning the CookerMoving the Cooker Fit the Handles LevellingHandles should be above the ﬁxings Pressure testing Fitting the splash backFitting a stability bracket Gas Connection Electrical Connection GrillOven check Fitting the plinth Tap adjustment Conversion to LP gasJets Stick on label Servicing Notes To Remove a Thermostat To Remove or Change a Hotplate BurnerTo Change Grill Controller To Change a Hotplate Tap To Adjust Oven Door Catch Keep To Change Oven Door Outer PanelTo Change Oven Door Catch To Change Oven Door Seal To Replace an Oven Fan To Remove the left hand Oven Bottom and Top ElementsTo Remove an Oven fan Element To Remove Grill Element Circuit Diagram Technical Data DimensionsThis cooker is category II2H3+ Connections