To Remove Oven Element | Rangemaster U109720 - 01 manual

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

21.To Remove Oven Element.

Disconnect from electricity supply. Remove oven inner back (see 18).

Remove 2 screws from the

top of the element and 1 from the bottom of the element

in side the oven. Lift element out carefully, disconnect the terminals connected to the

element noting their positions.

If it is not possible to disconnect the leads in this way, pull cooker

forward to gain access to the rear.

Remove screws securing the electric cover to the back sheet and remove cover and disconnect the terminals from the rear.

Fit new element, and reassemble in reverse order. Check operation of oven.

22. To change oven light bulb.

LH Oven

Remove the oven furniture and side linings. Remove the oven rear liner.

RH Oven

Remove the oven inner back (see 18). The oven light cover is now accessible. Unscrew the cover.

Unscrew the bulb.

Fit an Edison screw ﬁtting 15w 240v lamp, FOR OVENS. It must be a special bulb, heat resistant to 300°C.

23To Adjust the Oven Door Angle

The door bottom hinge can be adjusted to alter the angle of the door.

Loosen the bottom hinge ﬁxing screws and use the notch and a ﬂat bladed screwdriver to move the position of the hinge to set the hinge position.

Retighten the hinge screws.

Eﬀect of hinge adjustment – exaggerated for clarity

Centre line of hinge pin

Oven door omitted for clarityt

30

Image 30

Rangemaster U109720 - 01 manual To Remove Oven Element, To change oven light bulb, To Adjust the Oven Door Angle

Contents

Installation & Service Instructions U109720 Kitchener Electricity on Make sure that the cooker is wired in and switched onBe safe Peculiar smells Contents Hob Use only pans that are suitable for ceramic hobs Never cook directly on the surface Grill Remove the pan from the bottom of the grill compartment Ovens To time something that’s cooking minute minder ClockTo set the time of day To stop automatically Cooking using the timer Auto is showing, you want to reset to manual cookingClock Special Features Main Oven shelves Both Ovens Handyrack Oven lightTall oven shelves Page Oven cooking guide Hob Cleaning your cookerGrill Control Panel and Doors Tall Oven Main OvenSide panels of the main oven can be removed Troubleshooting Moving your cooker Left hand Main oven not coming on when automatic cooking Power failureLeft hand Main oven not coming on when turned on manually Oven temperature getting hotter as the cooker gets older Cleaning Table Outside of cooker Part Finish Recommended Cleaning MethodOvens General Safety Instructions Clean only parts listed in this guide Take care that no water seeps into the appliance Speciﬁcation of this cooker should not be alteredDo not use the surface as a cutting board Installation You will also need the following tools Positioning the Cooker Unpacking the CookerChecking the parts Moving the Cooker LevellingFitting a stability bracket Oven check Electrical ConnectionHotplate Fitting the plinth Door adjustment Customer careThank you Servicing Notes To Remove Grill Door To Adjust Main Oven Door Catch KeepTo Change Grill Controller To Remove Main Oven Door To Change Hotplate Burner Injector To Remove or Change a Hotplate BurnerTo Change Hotplate Control Taps To Change Hotplate Burner Electrode To Change Tall Oven Door Magnetic Latch To Adjust the Main Oven Door Catch KeepTo Change the Main Oven Door Latch To Remove Grill Element To Adjust the Oven Door Angle To Remove Oven ElementTo change oven light bulb Ratings Technical DataDimensions Ovens 1kW 02kW A21.65kW 56kW Key to circuit diagram Colour Code Page Page 271106