Rangemaster U109923 - 05 Installation, Positioning Your Appliance, Choosing the Right Location

4. Installation

Fig.4-1
ArtNo.600-0034 -
	����
Fig.4-2
���	��	��
���		���
��������������������
ArtNo.600-0033 - Door clearances

Fig.4-3

ArtNo.600-0009 - Removing the door

ArtNo.600-0011 - Disconnecting the pipes

Fig.4-4

Fig.4-5	Fig.4-6
�����������������
�������������	.600-0048 -
ArtNo.600-0047 -	water connector 2
DxD water connector
���������������
�������������
�����������������

Positioning Your Appliance

Choosing the Right Location

This appliance should be installed in a room that is dry and well ventilated. To ensure adequate ventilation, the refrigerator should be at least 15 mm clear on all sides from kitchen cabinetry (Fig.4-1). Any units placed above the appliance must be clear by 15mm to allow sufficient ventilation.

If locating the refrigerator close to a corner, sufficient spacing must be left for opening the doors and removing the shelves (Fig.4-2).

This appliance should be at least 100 mm from any electric or gas cooker and 300 mm from any coal or oil stove. If this is not possible, ensure that appropriate insulation is used.

Avoid exposing the appliance to direct sunlight, and sources of heat (such as radiators, heaters or cookers).

If this appliance is situated in a cold environment (such as a shed, outhouse or garage) it will affect its performance. You may find that the performance of the appliance is not consistent and this may damage foods. A consistent ambient temperature of 10 °C or above is recommended.

Removing and Installing the Doors and Drawers

In the event that you need to remove the refrigerator doors, please follow the door removal and installation instructions below.

It is suggested, for your safety, to have two or more people to assist you in completing the below task to avoid injury, product damage or property loss.

Door Removal and Installation

Undo the retaining screws on the top cover. Remove the top cover and place to one side for reinstallation.

Right-hand door

Using a suitable screwdriver, remove the top hinge screws and remove the hinge. Lift the refrigerator door off the lower hinge (Fig.4-3)and place it to one side.

Refit the door and cover in the reverse sequence.

Left-hand door

Disconnect the wire cable connector (Fig.4-4)above the left- hand hinge.

On the back of the appliance, remove the water pipe cover. Pull the upper securing clip off the water connector (Fig.4-5). Push down on the top of the connector to release the water pipe (Fig.4-6)and remove.

From the top of the left-hand door, pull out the water pipe until it is clear of the refrigerator body.

Using a suitable screwdriver, remove the top hinge screws and remove the hinge. Lift the refrigerator door off the lower hinge and place it to one side.

10