Rangemaster WP29M Remove The Filters And The Grease Drip Rails, Remove The Pan

4. REMOVE THE FILTERS AND THE GREASE DRIP RAIL(S)

A.Remove tape on filters.

Remove filters from hood and set aside.

NOTE: It is recommended to start with the central one.

B.Remove tape on grease drip rail (1). Lift out grease drip rail and set aside.

NOTE: The 60-inch width hood has 2 grease drip rails.

1

HD0175

5. REMOVE THE PAN

Using a Phillips no. 2 or Robertson no. 2 screwdriver, remove the screws retaining the pan (shaded part on illustration beside) to the hood. Remove the pan and set aside.

RETAINING SCREWS LOCATION

HD0176
6. INSTALL WOOD MOUNTING STRIP
Measure and mark a level line on wall above cooktop location for the wood
mounting strip (see illustration beside and under step 2). Remove wood mounting
strip from back of hood.
Use no. 10 - 2’’ flat head screws to secure the mounting strip to the drywall. Make
sure to hit the wall studs.
CAUTION
Due to the weight of this hood, ensure that the wood strip is attached
to all of the available studs (2 studs minimum for a 30’’ width hood,
more as hood width increases); not into the drywall alone.
HD0174A
1. Drywall	4. Wall anchor location
2. Wood mounting strip	5. Back of hood outline
3. Flat head screw	6. Wall studs

7. INSTALL THE FLUE AND/OR THE FLAT TOP COVER

7.1DUCTED INSTALLATION: A) OPTIONAL DECORATIVE FLUE AEWP SERIES

For a ducted installation, refer to the instructions sheet included with the optional decorative flue.

B)OPTIONAL FLAT TOP COVER ADPWP SERIES

For ducting through back of hood only, install on hood or on the Optional Decorative Flue AEWP Series. Refer to the instructions sheet included with the optional flat top cover.

7.2NON-DUCTED INSTALLATION: NON-DUCT KIT FLUE ANKWP SERIES

Refer to the installation sheet included with the non-duct kit for details.

NOTE: The Optional Flat Top Cover ADPWP Series can be installed on the Non-Duct Kit Flue ANKWP Series. Refer to the instructions included with the optional flat top cover.

- 7 -