13.INSTALL THE BLOWER (INTERIOR OR EXTERIOR BLOWER)
Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle and the power supply cord (B) onto the male connector inside the hood.
AB
! WARNING
Do not plug the two cords into each other.
HE0078
14.REINSTALL THE PAN
Using a Phillips no. 2 or Robertson no. 2 screwdriver and the retaining screws, reinstall the pan (previously removed in step 6) inside the hood (shaded part on illustration beside).
RETAINING SCREWS LOCATION
HD0176
15.REINSTALL GREASE DRIP RAIL(S) AND BAFFLE FILTERS
Reinstall grease drip rail(s) (1). The illustration beside shows how to reinsert the grease drip rail(s) into the range hood.
1 |
HD0181 |
CAUTION
Remove protective plastic film covering Evolution™ hybrid baffle filters before installing them.
Before reinstalling Evolution™ hybrid baffle filters, slide out the secondary micromesh filters from their back and remove all protective plastic film.
15.1DUCTED INSTALLATION:
Slide in the secondary filters into each baffle filters before reinstalling them on the hood.
15.2NON-DUCTED INSTALLATION:
Discard the secondary filters. Slide in the charcoal filters included in the
It is recommended to install side filters first and finish with center one(s).
1.Insert one end of Evolution™ hybrid baffle filter into the upper channel of the hood.
2.Raise the other end toward the inside of hood and insert in the grease drip rail of the hood.
Replacement filters are available from your dealer. See label inside hood for size and part number.
For charcoal filter replacement kit, see table on page 12.
1 | 2 |
HD0180 |
|
- 9 -
