21
System with 4 RF connector baseplate

Single IRD

This is the basic method for connecting your Raymarine Satellite TV
System.
The RF cable should be connected from RF1 to ‘LNB’, ‘ANT’ or ‘Satellite In’
on the rear panel of the IRD.

Twin IR Ds

You can connect two IRDs to your antenna as shown in the following
diagram.However, only one of the IRDs can be configured as a two satellite
receiver. The other IRD needs to be configured as a one satellite receiver.
The two satellite receiver determines which satellite is tracked, while the
other receiver can watch any channel which is available from the tracked
satellite.
As in the single IRD option the RF cables from the antenna base plate
should be connected to ‘LNB’, ‘ANT’, or ‘Satellite In’ on the rear panel of
the IRD.
Full details on configuring your system IRDs will be found in the relevant
Manufacturer’s handbook.
POWER
RF 2RF 1
RF 4RF 3
Television Monitor
(not supplied)
IRD
(not supplied)
Antenna baseplate
D7960_1
D9281_1
POWER
RF 2RF 1
RF 4RF 3
Television Monitor 1
IRD 1
Television Monitor 2
IRD 2
Antenna baseplate
D9282_1
81258_3.book Page 21 Wednesday, November 8, 2006 2:06 PM