Chapter 4: Calibration | 25 |
4.3 Intermediate calibration
Intermediate calibration enables you to:
•Check the instrument software version.
•Check the instrument status - either master (shown as RPTR NO) or repeater (shown as RPTR YES).
You cannot make any adjustments in Intermediate calibration.
Follow the procedure in the Intermediate calibration flow diagram.
INTERMEDIATE CALIBRATION
During normal operation
hold down | and | for approximately 4 seconds |
Software |
|
|
version |
| Note: |
|
| |
|
| If there is no key activity when |
|
| the Software version screen |
|
| is displayed, calibration will |
|
| time out to normal operation |
|
| after 5 seconds, |
ST40 |
| COMPASS |
Instrument status 
CAL
ST40 | COMPASS |
To return to normal operation from either screen,
hold down 
and 
for approximately 2 seconds
4.4 Dealer calibration
Dealer calibration enables you to set:
•User calibration on/off.
•Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This enables you to reapply the factory settings if you want to reset the instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
