Raypak 185, 335, 405, 265 installation instructions MOUNTING POWER VENT ASSEMBLY-continued

MOUNTING POWER VENT ASSEMBLY-(continued

11.Mount the PowerVent assembly bottom on the 6” vent. Twist the assembly downward. Snap the mounting brackets into their appropriate slot to hold the Power Vent in position. Note: While twisting you may notice some roughness, this is due to a tight seal between the 6” vent and the Power Vent flue box.

12.Re-mount the access panel.

13.Re-mount the front door along with the knurled screw on the heater.

Fig #9356

** NOTE: The 90° elbow may be used as a termination cap.

WIRING A POWERVENT ASSEMBLY TO AN APPLIANCE WITH IID IGNITION.

WARNING: Disconnect all electrical power to the unit before servicing to avoid potential shock injury or damage to the unit. To change voltages, follow wiring diagram for correct voltage connections. Improper wiring connections can burnout the relay and blower motor.

4