To Change Batteries
1.Remove cover on backside of the remote control. Install 3 AAA as shown on the cover and then
2.Once OPERATION steps 1 to 3 are completed, the receiver/valve and remote control are ready. Press any button on the remote control to initiate the recognition process between the receiver/valve and the remote control.
3.You may now use the functions as described in the REMOTE CONTROL section.
Fig 8. Comfort control wiring diagram
Part 5 Troubleshooting
Refer to Fig 6
1.Locate the LED light on the gas valve.
2.LED will blink after every valid command received from the remote control; this is not an error.
3.Failure codes may occur anytime after the pilot burner is lit.
4.The sequence is: failure code followed by light not blinking for 30 seconds.
5.In the event of multiple failure codes, the next failure code follows previous failure code by approximately 3 seconds.
If an error code 3 is observed while performing the testing, complete the following:
1.Make sure all the spade connectors are pushed all the way onto the terminals. If error code 3 still shows, go onto the next step.
2.Switch the two front thermopile leads with the back two. Be sure the white lead is connected to the spade marked with the white dot. If error code 3 still shows, replace the thermopiles.
Page 18 of 27
