Part 2: Installation Instructions
This gas fireplace must be installed by a qualified installer in accordance with AS5601 and all relevant local building codes.
For safe installation and operation please note the following:
1.This fireplace gives off high temperatures and should be located out of high traffic areas and away from furniture and draperies.
2.Children and adults should be alerted to the hazards of fireplace high surface temperatures and should stay away to avoid burns or ignition of clothing.
3.CAUTION: Due to high glass surface temperatures children should be carefully supervised when in the same room as the appliance.
4.Under no circumstances should this fireplace be modified or altered. Parts removed for servicing should be replaced prior to operating this fireplace again.
5.Installation and any repairs to this fireplace must be performed by a qualified installer, service agency or service person. A qualified service person should be contacted to inspect the fireplace annually.
6.Control compartments, burners and air passages in this fireplace should be kept clean and free of dust and lint. Make sure that the gas valve and pilot light are turned off before you attempt to clean this appliance.
7.The flueing system should be checked once a year and cleaned if required.
8.Keep the area surrounding this appliance clear of combustible materials, gasoline and other flammable vapour and liquids. This heater should not be used as a drying rack for clothing.
9.Under no circumstances should any solid fuels (wood, paper, coal or cardboard etc.) be used in this appliance.
10.The flow of combustion and ventilation air must not be obstructed in any way.
11.When this appliance is installed directly on carpeting, vinyl tile, linoleum or any combustible material other than wood, this fireplace must be installed on a metal or panel extending the full width and depth of the appliance.
12.This appliance requires adequate ventilation and combustion air to operate properly – refer to AS5601 ventilation and combustion air requirements.
13.This appliance must not be connected to a chimney flue serving a separate solid fuel burning fireplace.
14.When the fireplace is not in use it is recommended that the gas control valve be left in the OFF position.
