Assembly and SET-UP, Attaching the Front Wheel

ASSEMBLY AND SET-UP

A B

B A

1 Remove the packing material	2 Remove axle nuts (A) from the	3 Insert the tab on the safety
from the front fork.	axle bolt and insert the wheel into	washer (B) into the hole on the
	the front fork. Safety washers	front fork and tighten axle nuts
	should face outside of the fork.	using two 15mm open wrenches.

1 Face the handlebars forward	2 Tighten the collar clamp using a
with the throttle on the right and	5mm Allen wrench.
brake on the left, depress the
push button located on the front
fork and insert the handlebar
stem until the button locks
securely into the stem.

1 Slide the seat tube through the	2 The clamp of the luggage rack	3 Adjust the luggage rack to the
luggage rack and into the frame	should be above the seat clamp.	desired height and tighten the 4
tube down to the safety line on the	Adjust seat to the desired height.	bolts on the luggage rack with
seat tube.	Seure the seat by tightening the	5mm Allen wrench and 10mm open
	collar clamp bolt using a 5mm Allen	wrench.
	wrench.

WARNING: Failure to properly tighten the collar bolts may allow the handlebars to dislodge while riding and may cause you

to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.

Note: The cable and wire assembly from the handlebar must not be wrapped around the steering tube or handlebar. Sharp bends

or twisting of the brake cable can cause the brakes to malfunction.

WARNING: Failure to properly install and tighten the screws, nuts and bolts that afﬁx seat can cause you to lose control and crash.