ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
LEGS TO SAW BASE
1.Loosen lock knob (A) Fig. 8, and move
(B) to the rear position as shown. Then tighten knob (A).
2.IMPORTANT: Make certain the
3.Place Radial Arm Saw on its back and assemble legs
(C) Fig. 9 (three of which are shown assembled) to each corner of saw base (D) using sixteen 5/16-18 x 5/8" carriage head screws, 5/16" flat washers, 5/16" external tooth lockwashers, and 5/16-18 hex nuts. Place flat washer on bolt. Insert bolt through holes then assemble lockwasher and nut. Hand tighten, hardware at this time but do not completely tighten.
4.Stand the saw in the upright position and securely tighten all stand hardware.
A
B
Fig. 8
C
DC
Fig. 9
WRENCH HOOK TO
SAW BASE
Assemble wrench hook (K) Fig. 10, to the front right (as shown), or back left, side of saw base (D), using two #10 x 1/2" sheet metal screws.
D
K
Fig. 10
9
