Maintenance, Overload Protection | Porter-Cable RS830 specification

MAINTENANCE

OVERLOAD PROTECTION

The motor on your saw is equipped with a resettable overload relay (A) Fig. 82. If the motor shuts off or fails to start due to overloading, or low voltage, turn the switch to the “OFF” position, let the motor cool three to five minutes then push the reset button (A). The motor can then be turned on again in the usual manner. Some conditions that may cause overloading are; cutting stock too fast, using a dull blade, using the saw beyond its capacity, etc.

A

Fig. 82

27

Image 27

Porter-Cable RS830 instruction manual Maintenance, Overload Protection

Contents

Professional Radial Arm Saw General Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM Saws Qualified Electrician Check the Receptacle Power ConnectionsMotor Specifications Grounding Instructions Extension Cords Changing Voltage Operating Instructions Unpacking and Cleaning Radial ARM SAW Parts 811 912 Table Board Parts Assembly Legs to SAW BaseWrench Hook to SAW Base Removing Blade and Blade Guard from SAW Disconnect Machine from Power Source Table Supports Page HS a Adjusting Checking SAW Blade Travel Square to Fence Disconnect Machine from Power SourceTable Board Clamps and Table Boards Page Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To Table FJ a Adjusting IN/OUT RIP Scale Tongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to Machine Fastening SAW to the Floor Cutting Into Table Boards Locking Switch OFF Position Adjusting Ball Bearings Against TrackStarting and Stoping Radial ARM SAW Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating Column Changing Position of Bevel Clamp Handle Changing Position of Yoke Clamp HandleTable SURFACE, Raise Track ARM Adjusting Splitter and ANTI-KICKBACK Fingers Positive Stop Yoke IndexPositive Stop Bevel Index CB K Explanation of Operating Controls Operations Auxiliary Table Board Facing IN-RIPPING Compound Miter CuttingRipping OUT-RIPPING Overload Protection Maintenance Constructing a Push Stick Push StickPage Accessories PARTS, Service or Warranty Assistance