Radial ARM SAW Parts | Porter-Cable RS830 specification

RADIAL ARM SAW PARTS

4		5		6				1
4						7

2

3

		Fig. 4
1.	Radial Arm Saw	5.	5/16" Flat Washers (16)
2.	Legs (4)	6.	5/16" External Tooth Lockwashers (16)
3.	Table Supports (2)	7.	5/16-18 Hex Nuts (16)
4.	5/16-18x5/8" Carriage Head Screws (16)

7

Image 7

Porter-Cable RS830 instruction manual Radial ARM SAW Parts

Contents

Professional Radial Arm Saw General Safety Rules Avoid Kickback by Additional Safety Rules for Radial ARM Saws Qualified Electrician Check the Receptacle Power ConnectionsMotor Specifications Grounding Instructions Extension Cords Changing Voltage Operating Instructions Unpacking and Cleaning Radial ARM SAW Parts 811 912 Table Board Parts Legs to SAW Base AssemblyWrench Hook to SAW Base Removing Blade and Blade Guard from SAW Disconnect Machine from Power Source Table Supports Page HS a Disconnect Machine from Power Source Adjusting Checking SAW Blade Travel Square to FenceTable Board Clamps and Table Boards Page Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To Table FJ a Adjusting IN/OUT RIP Scale Tongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to Machine Fastening SAW to the Floor Cutting Into Table Boards Adjusting Ball Bearings Against Track Locking Switch OFF PositionStarting and Stoping Radial ARM SAW Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating Column Changing Position of Yoke Clamp Handle Changing Position of Bevel Clamp HandleTable SURFACE, Raise Track ARM Positive Stop Yoke Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Bevel Index CB K Explanation of Operating Controls Operations Auxiliary Table Board Facing IN-RIPPING Compound Miter CuttingRipping OUT-RIPPING Overload Protection Maintenance Constructing a Push Stick Push StickPage Accessories PARTS, Service or Warranty Assistance