ASSEMBLy AND SET-UP
qAttaching the Rear Caster Wheels
Required Tools: 5mm Allen wrench
1 Insert the caster bolt into the frame. If aligned correctly, the caster thread should go half way into the frame with no resistance.
Note: Make sure the spring washer is on the caster bolt before inserting the caster.
2 Using a 5mm Allen wrench, tighten the hex bolt located on the underside of the wheel cover until the caster bolt is all the way inside the frame.
Note: There should be no visible threading between the frame and the wheel cover (See Inset)
3 If you’re having trouble thread- ing the caster into frame, use a rag or small brush with a little WD- 40® to remove any excess particles that may be caught in or around the threading within the frame.
qAttaching the Seat
Required Tools: (2) 5mm Allen wrench
1 Remove the four coupling bolts from the frame using two 5mm Allen wrenches; one on top and one on bottom.
2Align the four holes in seat with the four holes in frame. Insert coupling bolts through the top and bottom of the frame.
3Tighten bolts using two 5mm Allen wrenches; one on top and one on bottom.
Need Help? Visit our web site for replacement parts and product support at www.razor.com, or call
4