Repair and Maintenance, Adjusting the Brakes

REPAIR AND MAINTENANCE

Turn power switch “OFF” before conducting any maintenance procedures.

qAdjusting the Brakes

Tools required: 10 mm open wrench

1 To adjust brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2.

2If brake is too tight or has too much slack, use a 10 mm open wrench to loosen the brake cable and adjust accordingly.

3Inspect the brake pads (A) for proper alignment against the wheel or excess wear. To realign brake pads, loosen the fixing nut (B) and adjust the pad to contact the rim. Retighten and readjust as needed. Verify proper brake function prior to riding the scooter.

qFront Wheel Replacement

Tools required: 10 mm open wrench and two (2) 16 mm open wrenches.

1 Using a 10 mm open wrench	2 Using two 16 mm open	3 Reassemble, adjust and
loosen the brake cable bolt.	wrenches, loosen the locknuts	tighten brake cable. Verify
	by turning the wrenches counter	proper brake function prior to
	clockwise. Remove wheel and	riding the scooter.
	install replacement wheel.
	Reference front wheel hardware
	sequence on this page.

qChain and Rear Wheel Replacement

Tools required: Phillips screwdriver and two (2) 13 mm open wrenches.

1 With a Phillips screwdriver,	2 Using two 13 mm open	3 To loosen the chain, pushing
loosen the two screws and	wrenches, loosen the locknuts	the tensioner down to create
remove the chain guard.	by turning the wrenches counter	some slack in the chain.
	clockwise. Reference rear wheel
	hardware sequence (page 6).