Razor E200 owner manual Attaching the Seat if applicable, Charging the Battery

Assembly and Set-Up

Front Tire

4 Using a bicycle style tire pump equipped for a Schrader-type valve, inflate the front tire to the PSI indicated on the sidewall of the tire.

qAttaching the Seat (if applicable)

1 Attach the seat to the	2 Unscrew the four screws on	3 Place the seat post on the
seat post with two 4mm key	the middle of the deck with the	deck and secure using the same
wrenches.	4mm key wrench and the phil-	4 screws.
	lips screwdriver.

Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or slightly tilted depending on your personal preference. Tighten securely. The seat tilt adjustment should not move when riding.

qCharging the Battery

Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use.

• Initial charge time: 18 hours	• Run time: Up to 40 minutes of continuous ride time
• Recharge time: up to 12 hours	• Average battery life: 250 charge/discharge cycles
When the scooter is not in regular
use, recharge the battery at least
once a month until normal use is
resumed.
Charger
Charger
Port
Charger
Plug
	1 Turn OFF power switch before	2 Plug the charger into a wall
	charging. Plug the charger into	outlet. If the lights on charger
	the charger port on the electric	do not light up, check the power
	scooter.	to the outlet. If necessary, try a
		different outlet.

WARNING: Always disconnect your scooter from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on

the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over- charge protection to prevent battery from being over-charged.

Charger will get warm during use. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.

WARNING: Failure to recharge the battery at least once a month may result in

a battery that will no longer accept a charge.

Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00AM - 5:00PM Pacific Time.

4