Razor E300s Assembly and SET-UP, Attaching the Handlebars, Inflating the Tires, Rear Tire

ASSEMBLY AND SET-UP

qAttaching the Handlebars

Tools required: 5 mm Allen wrench.

1 Loosen the collar clamp and	2 With the front wheel pointed
slide it upward. With a twisting	straight ahead and the handle-
motion, push and twist to slide	bars square to the front wheel,
the steering tube onto the fork.	tighten the clamp as shown.
	Tighten securely.

qInflating the Tires

Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your purchase. Always inflate tires to the correct PSI before first time use.

Rear Tire

Note: Make sure the cables/ wires are out of the way before inserting the stem in the fork.

WARNING: Failure to properly tighten the collar clamp may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.

Note: The cable and wire assembly from the handlebar must not wrap around the steering tube or handlebar. Sharp bends or twisting of the brake cable can cause the brakes to malfunction.

WARNING: Failure to remove the valve extender after inflating will cause the inner tube and/or adapter to be severed by the rear drive sprocket.

Note: If you lose the valve extender, contact customer service or one can be purchased at almost any auto parts store.

1Use the valve extender located inside the end of the right handlebar grip.

Front Tire

2Open the round cover located on the chain cover by sliding the cover upward. Align the opening in the drive sprocket with the valve stem. Thread the valve extender completely onto the valve stem and attach the pump. Inflate to the PSI indicated on the tire sidewall.

3Remove valve extender immediately after inflating and close the round cover.

WARNING:

Do not over inflate, as this could damage tire or wheel

Note: The pressurized air supplies found at gasoline stations are designed to inflate high-volume automobile tires. If you decide to use such an air supply to inflate your electric scooter tires, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the excess pressure immediately.

4 Using a bicycle tire pump equipped for a Schrader valve, inflate the front tire to the PSI indicated on the sidewall of the tire.

3