Razor E300s Usage, Attaching the Seat E300S Only, Starting the Scooter, Stopping the Scooter

ASSEMBLY AND SET-UP

qAttaching the Seat (E300S Only)

Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver.

1 Attach the seat to the seat	2 Remove the four screws on	3 Place the seat post on the
post with two (2) 4 mm Allen	the middle of the deck with the	deck and secure using the same
wrenches. See note below.	4 mm Allen wrench and the	4 screws.
	Phillips screwdriver.

Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or slightly tilted depending on your personal preference. Tighten securely. The seat tilt adjustment should not move when riding.

USAGE

qStarting the Scooter

To start unit, turn on power switch and twist throttle with both hands on the handlebar.

qStopping the Scooter

To stop unit, release the throttle and apply the brake until the unit comes to a complete stop.	Note: As an additional safety
	feature, the scooter is designed
	to cut power to the motor when
	the hand brake is applied.

Need Help? Visit our website for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the product I.D. code (located on the white label on your product or back of charger) available for better assistance.

4