RCA 811-DTA891W030 Program the supplied remote control, Your Converter Box is now ready for use

Setting up (continue)

3. Press 1 to start automatic channel search.

•When the scan finishes, the Channel List menu displays the found channels.

•Reposition the antenna and perform the automatic channel scan again if you cannot find all available channels by pressing MENU key.

•The Converter Box is also compatible with Smart Antennas which can provide improved reception over standard indoor antennas.

•If a Smart Antenna is connected, press 1 for Quick Scan or 2 for Full Scan. A full scan with Smart Antenna may take around 40-50 minutes.

4.The Channel List is displayed once scanning is finished Press or to select channel and OK to start viewing.

•You may also hide unwanted channels, refer to “Channel List” on page 8 for details.

Your Converter Box is now ready for use!

Tip: To continue to view non-digital TV broadcasts, if available, press the BOX on your remote to place the Converter Box in stand-by mode (red light), then switch your TV to any searched non-digital channel.

You must have the RF coaxial cable connected to your TV input, in order to watch non-digital TV broadcasts.

Program the supplied remote control

You can control T V sets of all major brands after programming the Converter Box remote control with the PGM key. RCA TV sets can be controlled directly without programming. Refer to the steps below and the separate Program Code leaflet to guide you through the programming.

1.Refer to the Program Code at the last pages of this booklet. Look for the brand of your TV set and a 3-digit program code next to it. There may be more than one program code available. Choose any one of them.

Program codes/Códigos de programa

Admiral 002, 128, 183, 189

Advent 191, 258, 260, 275

Adventura 129

3.Enter the 3-digit program code with the number keys. Press OK for confirmation. The signal indicator will be off when the program is done.

4.Press the volume keys on this remote control to check if they can adjust the volume of your TV set.

2.Press PGM on the remote control. The signal indicator on it remains lit.

signal indicator

•If you fail to control your TV set, repeat steps 2 to 4 to program again. Try another program code if there is more than one for your TV brand.

•If the signal indicator remains lit after blinking four times, you may have entered the wrong code. Repeat steps 3 to 4 to program again. Make sure you have correctly entered the code.

•You can still use your TV remote control to turn on your TV set, select input source and control the volume.

6