Power sources Antenna connections

NOTES: ALWAYS TURN THE TV/DVD TO “OFF”

BEFORE SWITCHING THE IGNITION OF THE CAR ENGINE.

Make sure that the negative terminal of the battery is grounded.

This set is designed for use with negative grounding systems only.

Use the supplied car cord only.

When the TV/DVD is not in use, always discon- nect it from the car cigarette lighter socket to avoid a battery drain.

If the TV/DVD is to be directly connected to a 12V DC power source, for example, recrea- tional vehicle (RV) applications, make sure the power cord is connected after the ignition switch to avoid battery drain.

Do not operate the TV/DVD if the car battery is weak. Peak current from the car alternator could blow the DC fuse.

Check the battery’s charge level regularly when the TV/DVD is used in a vehicle.

REPLACING THE FUSE IN THE CAR BATTERY CORD PLUG

If the fuse in the car battery cord plug blows, replace it with a new 8 A fuse (Fast Blow Type) as shown below. Unscrew the tip of the plug to remove.

PLUG

8A FUSE

TIP

If you are using an indoor or outdoor antenna, fol- low the instructions below that correspond to your antenna system. If you are using a cable TV service (CATV), see page 13 for Cable TV connections.

Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire)

Connect the 75 ohm cable from the combination VHF/ UHF antenna to the Antenna Jack.

If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the use of the 300-75 ohm Matching Transformer may be necessary.

Antenna Jack

Antenna Jack

75 ohm Coaxial

Cable

300-75 ohm Matching Transformer

Combination VHF/UHF Antenna (Separate VHF and UHF 300 ohm twin-lead wires)

Connect the UHF 300 ohm twin-lead wire to the Combiner (not supplied). Connect the VHF 300 ohm twin-lead wire to the 300-75 ohm Matching Transformer. Attach the Transformer to the Combiner, then attach the Combiner to the Antenna Jack.

Antenna Jack

300-75 ohm Matching

Transformer

Combiner

UHF 300 ohm

VHF 300 ohm

Separate VHF/UHF Antennas

(75 ohm VHF cable and 300 ohm UHF twin-lead wires)

Connect the VHF 75 ohm cable and UHF 300 ohm twin-lead wire to the Combiner (not supplied). Attach the Combiner to the Antenna Jack.

Antenna Jack

VHF 75 ohm

Combiner

UHF 300 ohm

IMPORTANT: Go to page 18 to choose the signal and search for channels.

12

Page 12
Image 12
RCA 9V400TD manual Power sources Antenna connections, Replacing the Fuse in the CAR Battery Cord Plug