RCA CC6263 manual Date and Time Display, Install the Clock Lithium Cell, To Remove Lithium Cell

Date and Time Display

Install the Clock Lithium Cell

The clock cell indicator flashes for a few seconds in the viewfinder when you turn on the camcorder if the cell is not installed or needs replacing.

Clock Cell

Compartment

Clock Cell Holder

Insert Object Here to Remove Cell

Clock Cell

(+ Side Facing Out)

1.Make sure camcorder is turned off, and remove any power supply attached to the camcorder.

2.Pull the clock cell holder out of the clock cell compartment.

3.Insert the clock cell with the “+” terminal facing out, and press it in.

4.Place the clock cell holder into the clock cell compartment. Be sure to insert the holder fully into the compartment.

To Remove Lithium Cell

To remove battery, insert a pointed nonmetallic object between battery and clock cell holder and lift.

Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell, and never short the + and – sides of the cell.

17