
Using the Remote Control
Clearing a Learned Function
To delete a learned button function, use the procedure below.
1.Press and hold the component button (the component button lights). Then press and hold the CLEAR button for 3 seconds. Continue depressing both buttons (the component mode button
2.Release the component and CLEAR buttons (the component button being programmed turns on). Remote is now in Clear learned function mode.
3.Press and release the button where learning is to be cleared. The component button blinks off then back
4.Repeat steps 1 through 3 until all buttons’ learned functions have been cleared.
Note: If an invalid button is pressed, the component mode button(s) flashes 4 times and the selected component button stays on and remote remains in Clear Learned Function mode. Repeat step 3.
5.Press the CLEAR button and your HDTV Monitor remote returns to its original operation mode.
Deleting ALL Learned Functions
This procedure erases all learned functions in every component mode of the remote.
1.Press and hold the CLEAR button (the current component button lights). Then press and hold the ON•OFF button (component button light turns off for 3 seconds, flashes, turns on and off) while continuing to hold CLEAR.
2.Release both buttons (current component button turns on).
3.Press any component button to delete all learned functions in all modes. Remote is automatically exited from this mode.
Note: Pressing the CLEAR button will NOT delete all learned functions, but will exit the Delete mode.
28 | Chapter 2 |