RCA D44LPW134 manual TV+ A/V Receiver or Speakers, Front Panel Buttons

Connections & Setup

					A/V RECEIVER
CD		TAPE	TV		VCR
IN	IN	OUT	IN	IN	OUT

R

L

Connect to either FIXED or VARIABLE Output

TV

										AUDIO/VIDEO
			COMPONENT INPUTS							OUTPUT
										V	SUB
			CMP1		CMP2
					COMPOSITE INPUTS					ANTENNA/
										CABLE
		Y		Y	S-VIDEO	V	L	R	VID1	LEFT	LEFT
		PB	L	PB	L					RIGHT	RIGHT
Wired	DVI-HDTV	L							VID2
IR									FOR FACTORY
		PR	R	PR	R	V	L	R	USE ONLY	FIXED	VARIABLE
		R								AUDIO	AUDIO

TV+ A/V Receiver or Speakers

These are two different ways your TV uses a component to hear audio.

Connect audio cables to either the FIXED or VARIABLE AUDIO L and R OUTPUT jacks and to the Audio Inputs on the A/V receiver.

•FIXED provides fixed-level audio output from the TV. This audio output is ideal for connecting to an A/V receiver that has its own volume control.

•VARIABLE provides variable-level audio output. Volume levels can be controlled by the volume controls on the TV and TV remote control.

MENU/OK CH CH VOL VOL

Notes: The front panel illustration shows a typical front panel layout. The exact look may be different from the one on the front of your TV.

If you use the Front Button Block feature, the front panel no longer provides access to the menus. The Front Button Block feature disables all front panel buttons but not the jacks. For more information, see Chapter 3.

Front Panel Buttons

If you cannot locate your remote, you can use the front panel of your TV to operate many of the TV’s features.

Power Indicator Light Status

On	TV is on
Off	TV is off (standby mode)
Blinks	Light blinks 5 times every 30 seconds: Lamp is trying to turn
	on. If the TV doesn’t turn on after 5 minutes, then the light
	will double-blink four times and then remain on—try one of
	the following options:
	Lamp door is open. Locate the door on the side of the TV and
	close it. Turn off the TV and turn back on. The lamp should
	turn on.
	Lamp is dead. You can replace the lamp yourself follow-
	ing the instructions on page 55. Go to page 60 for ordering
	information.
	Power supply within TV may need service. Go to page 58 for
	warranty information.

MENU/OK Brings up the Main menu. When the menu system is displayed, pressing MENU/OK selects highlighted items.

CH Scans down through the channel list. In the menu system, it moves the highlight down and adjusts menu controls.

CH Scans up through the current channel list. In the menu system, it moves the highlight up and adjusts menu controls.

VOL Decreases the volume. In the menu system, it moves the highlight left to items and adjusts menu controls.

VOL Increases the volume. In the menu system, it moves the highlight right to items and adjusts menu controls.

(Power button and indicator) Turns the TV on and off. The indicator lights when TV is on. Your HDTV’s lamp has a cool-down period when the TV is turned off, and a warm up period when the TV is turned on. If you try to turn the TV on during a cool-down, you will hear audio and then shortly after the picture will be displayed. This could take up to one minute. For different light status of the indicator, see above.

also turns the front panel backlighting on.

18 Chapter 1