3-Way HDMI Switcher with IR Learning
DH3HSL User’s Guide
Thank you for buying the
Features
•Supports 480i, 480p, 720p, 1080i and 1080p screen resolutions.
•Supports HDCP compliant devices.
•Easy to install and simple to operate.
Installation
1.Use HDMI cables to connect HDMI sources to the inputs on the rear panel of the switcher.
2.Connect the cable from your HDMI display to the switcher output.
3.Plug the supplied 5V DC adaptor into the switcher DC input. The LED power indicator lights green. Note: The power unit is intended to be oriented in a vertical or floor mount position.
4.Select the desired input sources by pressing the appropriate button on front of the switcher or by using your remote control after programming the Learning function of the switcher outlined in the following section. The related LED indicator on the front panel indicates which input is selected. The default input is INPUT1.
Learning Function
This switcher is equipped with a unique Learning circuit, which allows it to learn the on/off commands from your infrared component remote(s) so that you can use them to toggle through inputs.
Follow these instructions to activate the Learning function:
1.Press the LEARN key on the front of the switcher panel. The LEARN LED light turns on.
2.Press the INPUT key on the front of the switcher for the component remote you wish to program. For example, if you want to program your DVD remote to operate the switcher and your DVD is connected to INPUT 2 on the back panel, press the INPUT 2 key. The LED light for the input you pressed turns on.
Note: When programming the Learning function, be sure to
3.As you connect your components to the input jacks, note which component you have connected to each jack in the space provided below. This information is important to have handy and is necessary when programming remotes to operate the switcher.
4.Point your remote at the switcher then press and hold the key on your remote that turns on the component whose content you want to play on your display device (HDTV). The INPUT key LED light turns on. A few seconds later, the LEARN LED indicator light blinks for five seconds and turns off. The INPUT LED indicator light turns back on.
5.The Learn function is complete. Your remote now switches to the appropriate source.
6.Repeat this procedure for each additional remote you wish to program for components connected to the other inputs.
Note: Universal remotes can also be programmed in the same manner to operate the switcher. You must be sure you have the remote in the operational mode that corresponds with the component plugged into that input on the back of the switcher.
Note: After the Learning function is completed, when a component is turned on, the switcher automatically selects
that input.
