Motorola manual Installing PMC Modules on the CPCI-6115

Installing PMC Modules on the CPCI-6115 Hardware Preparation and Installation

The PMC 2 I/O voltage key should be installed in the appropriate position for the PMC to be used. If installed in the +5 V position, PMC 2 is set to +5 V I/O. If installed in the +3.3 V position, PMC 2 is set to +3.3 V I/O. If the PMC accepts either key, install the key in the +3.3 V position (factory default). +3.3 V I/O voltage is required for any PCI/PCI-X operation faster than 33 MHz.

6.Slide the edge connector of the PMC module into the front panel opening from behind and place the PMC module on top of the baseboard. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors (J11/12/13/14) or (J21/22/23/24) on the CPCI-6115.

7.Insert the four short Phillips screws, provided with the PMC, through the holes on the bottom side of the CPCI-6115 into the PMC front bezel and rear standoffs. Tighten the screws.

8.Reinstall the CPCI-6115 assembly in its proper card slot. Be sure the module is well seated in the backplane connectors. Do not damage or bend connector pins.

9.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source, and turn the equipment power on.

If the PMC provides rear I/O, refer to Chapter 3, Controls, LEDs, and Connectors for the pin assignments. Connectors on the CPCI-6115-MCPTM transition module provide rear panel access to these signals.

CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 45