Motorola CPCI-6115 manual Baseboard Preparation, Equipment Required, Configuring the Hardware

Hardware Preparation and InstallationEquipment Required

Table 2-4 Startup Overview (continued)

Task	Section or Manual Reference	Page
Install the PMC Module (if required)	Installing PMC Modules on the CPCI-6115	43
Install the CPCI-6115 in the chassis.	Installing the CPCI-6115 Baseboard	46
Install the transition module.	Appendix A, Transition Module Preparation	113
	and Installation
Connect any other equipment you will be	Connecting to a Console Port	47
using.
Power up the system	Applying Power	47

2.4.2Equipment Required

The following equipment is required to complete an CPCI-6115 system:

zCompactPCI or compatible system enclosure

zSystem console terminal

zOperating system (and/or application software)

zDisk drives (and/or other I/O) and controllers

The CPCI-6115 baseboards are factory-configured for I/O handling via its front panel, installed PMCs or a rear transition module that is specifically designed for the CPCI-6115 product family.

2.5Baseboard Preparation

This section discusses certain hardware and software tasks that may need to be performed prior to installing the board in a CompactPCI or PICMG 2.9 compliant chassis.

2.5.1Configuring the Hardware

To produce the desired configuration and ensure proper operation of the CPCI-6115, you may need to carry out certain hardware modifications before installing the module.

Most options on the CPCI-6115 are software configurable. Configuration changes are made by setting bits in control registers after the board is installed in a system. The control registers are described in the CPCI-6115 CompactPCI Single Board Computer Programmer's Reference Guide, and other vendor publications.

Jumpers are used to control those options that are not software configurable. These jumper settings are described further on in this section.

36 CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)