Motorola manual Installing the CPCI-6115 Baseboard

Hardware Preparation and Installation Installing the CPCI-6115 Baseboard

2.7.2Installing the CPCI-6115 Baseboard

Procedure

With PMC modules installed (if applicable) and headers properly configured, proceed as follows to install the CPCI-6115 in the CompactPCI chassis:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.In a non-hot-swap system, perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the CompactPCI modules.

Product Damage

Inserting or removing modules in a non-hot-swap chassis with power applied may result in damage to module components. The CPCI-6115 is a hot-swappable board and may be inserted in a hot-swap chassis, such as a CPX2000, CPX8000 or MXP3000 series chassis with power applied.

Check to make sure your chassis is hot swap compliant.

Personal Injury or Deat

Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing and adjusting.

3.Remove the filler panel from the appropriate card slot.

4.Set the VIO on the backplane to either +3.3 V or +5 V (the CPCI-6115 is a universal board), depending upon your CompactPCI system signaling requirements and ensure the backplane does not bus J3 or J5 signals.

5.Slide the CPCI-6115 into the appropriate slot. Grasping the top and bottom injector handles, be sure the module is well seated in the P1 through P5 connectors on the backplane. Do not damage or bend connector pins.

6.Secure the CPCI-6115 in the chassis with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions.

7.Replace the chassis or system cover(s), making sure no cables are pinched. Cable the peripherals to the panel connectors, reconnect the system to the AC or DC power source and turn the equipment power on.

46 CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)