Motorola CPCI-6115 manual IDE CompactFlash Connector, PMC I/O Module Connectors, Pin

IDE CompactFlash Connector Transition Module Preparation and Installation

5.5.1IDE CompactFlash Connector

One 50-pin Type II CompactFlash card header connector located on both standard and MXP versions of the CPCI-6115-MCPTM transition module provides the IDE interface to one CompactFlash plug-in module. This CompactFlash interface is connected to the primary IDE channel. The pin assignments for these connectors are as follows:

Table 5-3 CompactFlash IDE Connector Pin Assignments, J1

Pin		J1		Pin
1	GND		NO CONNECT	26
2	DD3		DD11	27
3	DD4		DD12	28
4	DD5		DD13	29
5	DD6		DD14	30
6	DD7		DD15	31
7	CS1FX1_L		CS3FX1_L	32
8	GND		NO CONNECT	33
9	GND		DIOR_L	34
10	GND		DIOW_L	35
11	GND		+5 V	36
12	GND		INTRQ1	37
13	+5 V		+5 V	38
14	GND		MASTER/SLAVE	39
15	GND		NO CONNECT	40
16	GND		DRESET_L	41
17	GND		DIORDY	42
18	DA2		NO CONNECT	43
19	DA1		+5 V	44
20	DA0		DASP	45
21	DD0		PDIAG	46
22	DD1		DD8	47
23	DD2		DD9	48
24	NO CONNECT		DD10	49
25	NO CONNECT		GND	50

5.5.2PMC I/O Module Connectors

There are two pairs of 64-pin surface mount connectors on both the standard and MXP version of the CPCI-6115-MCPTM to provide an interface for two optional add-on PMC I/O modules. Each module has an identical PMC I/O connector and a unique Host I/O connector. All serial port signals are at TTL levels. The pin assignments are as follows:

CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 93