Motorola CPCI-6115 manual LPaDA+ TX1+ LPaDA-TX1

CompactPCI User I/O ConnectorTransition Module Preparation and Installation

Table 5-6 PMC I/O Modules 1 and 2 - PMC I/O Connector Pin Assignments, J14/24 (continued)

Pin		J14/J24		Pin
41	PMC IO41		PMC IO42	42
43	PMC IO43		PMC IO44	44
45	PMC IO45		PMC IO46	46
47	PMC IO47		PMC IO48	48
49	PMC IO49		PMC IO50	50
51	PMC IO51		PMC IO52	52
53	PMC IO53		PMC IO54	54
55	PMC IO55		PMC IO56	56
57	PMC IO57		PMC IO58	58
59	PMC IO59		PMC IO60	60
61	PMC IO61		PMC IO62	62
63	PMC IO63		PMC IO64	64

5.5.3CompactPCI User I/O Connector

Connector J3 is a 95-pin AMP Z-pack 2mm hard metric type AB connector. This connector routes the I/O signals for the PMC1 I/O, and two 10/100/1000Base-T ethernet ports. The pin assignments for J3 on the processor board and on the CPCI-6115-MCPTM are as follows:

(Outer row F is assigned and used as ground pins but is not shown in the table).

Table 5-7 User I/O Connector Pinout, J3

	Pin	Row A	Row B	Row C	Row D	Row E	Pin
	19	GND	+12 V	-12 V	GND	GND	19
	18	LPa_DA+ (TX1+)*	LPa_DA-(TX1-)*	GND	LPa_DC+*	LPa_DC-*	18
	17	LPa_DB+ (RX1+)*	LPa_DB-(RX1-)*	GND	LPa_DD+*	LPa_DD-*	17
	16	LPb_DA+ (TX2+)*	LPb_DA-(TX1-)*	GND	LPb_DC+*	LPb_DC-*	16
	15	LPb_DB+(RX2+)*	LPb_DB-(RX2-)*	GND	LPb_DD+*	LPb_DD-*	15
	14	+3.3 V	+3.3 V	+3.3 V	+5 V	+5 V	14
	13	PMC1IO5	PMC1IO4	PMC1IO3	PMC1IO2	PMC1IO1	13
	12	PMC1IO10	PMC1IO9	PMC1IO8	PMC1IO7	PMC1IO6	12
	11	PMC1IO15	PMC1IO14	PMC1IO13	PMC1IO12	PMC1IO11	11
	10	PMC1IO20	PMC1IO19	PMC1IO18	PMC1IO17	PMC1IO16	10
	9	PMC1IO25	PMC1IO24	PMC1IO23	PMC1IO22	PMC1IO21	9
	8	PMC1IO30	PMC1IO29	PMC1IO28	PMC1IO27	PMC1IO26	8
	7	PMC1IO35	PMC1IO34	PMC1IO33	PMC1IO32	PMC1IO31	7
	6	PMC1IO40	PMC1IO39	PMC1IO38	PMC1IO37	PMC1IO36	6
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)							97