Motorola CPCI-6115 manual Ethernet, Dioral

Transition Module Preparation and InstallationCompactPCI User I/O Connector

Table 5-7 User I/O Connector Pinout, J3 (continued)

Pin	Row A	Row B	Row C	Row D	Row E	Pin
5	PMC1IO45	PMC1IO44	PMC1IO43	PMC1IO42	PMC1IO41	5
4	PMC1IO50	PMC1IO49	PMC1IO48	PMC1IO47	PMC1IO46	4
3	PMC1IO55	PMC1IO54	PMC1IO53	PMC1IO52	PMC1IO51	3
2	PMC1IO60	PMC1IO59	PMC1IO58	PMC1IO57	PMC1IO56	2
1	IPMI_PWR	PMC1IO64	PMC1IO63	PMC1IO62	PMC1IO61	1

*Not connected on MXP version

Signal Description
PMCIO:
PMC1IO(64:1)	PMC1 I/O signals 1 through 64
Ethernet:
PORTn_TXP	high side of differential transmit data
PORTn_TXN	low side of differential transmit data
PORTn_RXP	high side of differential receive data
PORTn_RXN	low side of differential receive data

5.5.4CompactPCI User I/O Connector

Connector J5 is a 110 pin AMP Z-pack 2mm hard metric type B connector. This connector routes the I/O signals for the PMC2 I/O signals, the IDE port, four asynchronous serial ports and I2C. The pin assignments for J5 on the processor board and the CPCI-6115-MCPTM are as follows:

(Outer row F is assigned and used as ground pins but is not shown in the table).

Table 5-8 User I/O Connector Pinout, J5

	Pin	Row A	Row B	Row C	Row D	Row E	Pin
	22	DRESET_L	COM4_TXD	COM3_TXD	COM2_TXD	COM1_TXD	22
	21	INTRQA	COM4_RXD	COM3_RXD	COM2_RXD	COM1_RXD	21
	20	CS1FXA_L	CS3FXA_L	DA2	MXDI	MXDO	20
	19	Not Connected	DIORDYA	DA1	MXCLK	MXSYNC#	19
	18	DIOWA_L	DA0	TMCOM1_L	I2C_CLK	I2C_DATA	18
	17	GND	DD14	DD15	DIORA_L	Not Connected	17
	16	DD9	DD10	DD11	DD12	DD13	16
	15	DD5	DD6	GND	DD7	DD8	15
	14	DD0	DD1	DD2	DD3	DD4	14
	13	PMC2IO5	PMC2IO4	PMC2IO3	PMC2IO2	PMC2IO1	13
98		CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)