First Things First
Before Plug-In
EN | CABINET | WASHER |
| CABINET |
OVERHANG |
| BOTTOM | ||
|
|
|
| SPACERS |
|
|
|
| 3/ " MINIMUM |
|
|
|
| |
| EQUAL TO OR |
|
| 8 |
|
|
|
| |
| LONGER THAN |
| 3/4" MAXIMUM | |
| CABINET |
| ||
| OVERHANG |
|
|
|
SELECTED SCREWS WHICH MEET MINIMUM,
BUT DO NOT EXCEED MAXIMUM LENGHT.
5. | Insert screws FROM INSIDE THE CABINET. The |
| washers must be used on metal cabinets, and |
| on wood cabinets if you did not countersink |
| the drilled holes. Position washers, flat side |
| down, and place screws into the holes. |
| If your cabinet does not have an |
| overhang, go to Step 7. |
6. | Hold screw heads down while you push the |
| selected spacers onto the screws under the |
| cabinet. Be sure to push up spacers until they |
| are firmly against the cabinet bottom and/or |
| fully nested (if more than one is used). |
7. | Align radio under the screws. Hold the screw |
| holes in the top of the clock radio against the |
8.Extend cord towards electrical outlet and secure by using the Cord Hooks to hold cord out of the way. For most attractive appearance, place Cord Hooks at back edge of cabinet (on or next to wall) directly over outlet to be used. To attach Cord Hooks, peel off adhesive back and attach to a clean, dry surface on underside of cabinet or back wall. Plug Cord into
Automatic Time Set
Selecting Time Zone
The Time Zone switch is located in the battery compartment on the side of the unit.
Open the compartment door by rotating the
lock in the direction of the arrow 
.
TIME ZONE - Slide the switch to select time zone.
Refer to Figure 1 for U.S. Time Zone details. Refer to Figure 2 for Canadian Time Zone details.
Daylight Saving Time (DST)
After selecting time zone and plugging in your unit, daylight saving time must be activated for those areas observing such change.
The daylight saving button is located in the battery compartment on the side of the unit. Press and hold the DAYLIGHT SAVING button
until the icon lights on the display.
To disable daylight saving time, press and hold again until the icon no longer lights.
!
Warning:
Please avoid playing with these buttons after entering the Clock set mode.
EN
mounting screws and partially tighten the |
screws. |
Do not fully tighten until all 3 screws have |
been started. (The top front edge of the clock |
radio should clear the overhang.) |
Select 1 for Eastern Daylight Time Select 2 for Central Daylight Time Select 3 for Mountain Daylight Time Select 4 for Pacific Daylight Time
5 
6
