Connections & Setup
Digital Optical cable
Connecting Your TV to a Receiver with Dolby® Digital
If you own a receiver with Dolby® digital decoding or PCM
•Connect one end of the optical cable to the DIGITAL AUDIO OUTPUT (OPTICAL) jack on your TV and to the Digital Optical Input jack on your receiver/amplifier receiver.
•If your receiver can decode Dolby digital and PCM, go to the Audio menu, select Advanced Audio menu, then Digital Audio Output. Select AutoSelect (recommended) or PCM.
•If your receiver can decode only PCM, select PCM.
Setting Up Your TV
•Plug in the TV.
Note: When you first plug your TV into an outlet, the Power indicator on the front panel will light and blink for approximately 30 seconds and then go off during the initialization of the TV. This happens only when the TV is unplugged and plugged back in. The TV can only be turned on after the Power indicator goes off.
•Put batteries in the remote.
•Turn on the TV.
TV
MENU | CLEAR |
Use these buttons during the Assisted Setup
Tip
To access the initial setup menus at a later time, press MENU, choose Setup Options, then Assisted Setup.
Remote Control Buttons Used for the Assisted Setup
To use the TV’s menus, first press the TV button on the remote control to put the remote in TV mode. When the Assisted Setup screen appears, use the arrow buttons to highlight one of the items listed in the menu. Use the up or down arrow button to move up or down. Use the right or left arrow button to move right or left.
To select the item that you’ve highlighted, press OK.
Note: Highlighted means that the menu item stands out from other menu items on the list (appears darker, brighter, or a different color).
Complete the Assisted Setup
Your TV’s menu system allows you to customize your TV’s features.
Dolby and the
Chapter 1 |
