RCA MR29410 Connecting Cable TV, Antennas with 75-ohm Round Leads, Separate VHF and UHF Antennas

1577575A.02 11/15/01 10:04 AM Page 2

I N S TA L L AT I O N

Antennas with 75-ohm Round Leads

1

Plug the antenna lead into the VHF/UHF terminal on the bottom of the back panel.

Separate VHF and UHF Antennas

If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires a an optional combiner-adaptor (available at most electronics stores).

Connecting Cable TV

To connect to a cable TV system, follow the instructions below.

Cable without a Cable Box

1

Plug the incoming cable into the VHF/UHF antenna terminal on back of the TV.

▼ Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.

Connecting to a Cable Box that Descrambles All Channels

1

Find the cable that is connected to the ANTENNA OUT terminal on your cable box.

2

Connect the other end of this cable to the VHF/UHF antenna terminal on the back of the TV.

▼ This terminal might be labeled

“ANT OUT,” “VHF OUT,” or simply, “OUT.”

2.2 CHAPTER TWO: INSTALLATION