RCA MR29410 Connecting to a Cable Box that Descrambles Some Channels, ANT IN, VHF IN, or simply

1577575A.02 11/15/01 10:04 AM Page 3

I N S TA L L AT I O N

Connecting to a Cable Box that Descrambles Some Channels

If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of coaxial cable. (These items are available at most electronics stores.)

1

Find and disconnect the cable that is connected to the ANTENNA IN terminal on your cable box.

▼ This terminal might be labeled

“ANT IN,” “VHF IN,” or simply, “IN.”

2

Connect this cable to a two-way splitter.

3

Connect a coaxial cable between an OUTPUT terminal on the splitter and the IN terminal on the cable box.

4

Connect a coaxial cable between the ANTENNA OUT terminal on the cable box and the B–IN terminal on the A/B switch.

5

Connect another cable between the other OUT terminal on the splitter and the A–IN terminal on the RF (A/B) switch.

6

Connect the last coaxial cable between the OUT terminal on the RF (A/B) switch and the VHF/UHF terminal on the rear of the TV.

After you’ve made this connection, set the A/B switch to the “A” position for normal viewing. Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B,” you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)

CHAPTER TWO: INSTALLATION 2.3