RCA MR29410 manual Connecting VHF and UHF Antennas, Antennas with 300-ohm Flat Twin Leads

1577575A.02 11/15/01 10:04 AM Page 1

2

Chapter 2

I N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this, see “Antennas with 300-ohm Flat Twin Leads,” below.

If your antenna has one lead that looks like this, see “Antennas with 75-ohm Round Leads,” on page 2.2.

If you have two antennas, see “Separate

VHF and UHF Antennas,” on page 2.2.

NOTE: Illustrations are for representation only. Your product and on-screen displays might differ.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow the directions below.

1

Place the wires from the twin leads under the screws on the 300-75 ohm adaptor (not sup- plied). Use a screwdriv- er to tighten the screws.

2

Plug the adaptor into the VHF/UHF terminal on the bottom of the back panel.

CHAPTER TWO: INSTALLATION 2.1