l-
)RlGHT[
FRONT
-ANTENNA -
I | - | I |
ANTENNA CONNECTIONS
NOTE: On all speaker connections, be sure that the bare end of each lead makes contact with the terminal.
To connect two surround speakers (not included):
lUse only 8D speakers. Speakers with specifications other than 851may be damag- ed or may damage the system . Such damage becomes the owner’s respon- sibility.
lFollow the same steps used to attach front speakers, but use the terminals label- ed SURROUND SPEAKERS to make the connections. Be sure to connect positive (+) to red terminals and negative
To aim the speakers and adjust them for optimal performance, see “Placing Speakers,” next.
Placing Speakers
The diagram below shows suggested arral )ements of front and surround speakers.
Ipiziq
FRONT
Connecting the Antennas
Two antennas are supplied with your unit: an AM loop antenna and an FM wire antenna. These connect to the rear panel of the Tuner/Amplifier unit. Antennas must be connected for proper AM and FM reception.
lConnect the AM antenna to the two terminals labeled “AM LOOP” Press tabs to open and insert either bare wire lead into either terminal. Place antenna on a flat surface and adjust position for best AM reception.
lConnect the bare wire lead of the FM antenna to either one of the ter- minals labeled “FM 3OOD.” Press tab to open terminal and insert the lead . Extend the antenna to its full length and adjust for best FM reception.
NOTE: On all antenna connections, be sure that the bare end of each lead makes contact with the terminal.