RCA RS2058 user manual Installation, Using the FM and AM Antennas, Connecting the Speakers

RS2058 EN_Sirius 8/5/06 10:55 AM Page 10

Getting Started

	Using the FM and AM Antennas
EN
	Before you use your audio system, you’ll want to
	make sure both the FM and AM antennas are
	positioned properly. Uncoil the FM antenna at
	the back of the unit, making sure it is fully
	extended (you may even want to tape it to the
	wall behind the unit if possible. The higher the
	better.) You’ll also need to connect the AM
	antenna loop to the back of the unit if you listen
	to AM stations. Rotate the AM loop antenna for
	better reception.
	Connecting the Speakers
	Each speaker has a black (negative) and a red
	(positive) jack. When connecting the speakers,
	match the red wires to the red jacks and the
	black wires to the black jacks.
	Speaker Wire Connection

Connecting the Sirius ConnectTM Home Tuner

To use Sirius Satellite Radio, you need to connect a Sirius ConnectTM Home Tuner (purchased seperately) to the unit and subscribe to the Sirius Satellite Radio. To learn more about Sirius Satellite Radio, see page 16.

After purchasing the tuner, follow the below steps to connect the tuner.

1.Make sure the unit is in STANDBY mode (Display shows the clock and backlight is off). If necessary, press ON/STANDBY on the front panel to turn off the unit.

2.Connect the tuner to the Sirius socket at the rear panel of the unit.

3.Connect the supplied antenna from the tuner package. Follows the instruction on the User’s Manual of the Tuner. Make sure the tuner is powered by its AC adapter.

4.Press ON/STANDBY on the front panel to turn on the unit.

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

Installation

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

Front View	4 inches
4 inches	4 inches

Side View
	4 inches

2

inches

3