RCA RT2600, RT2350BK manual Using the Remote to Control Additional Components, Fm/Am

Operating your Receiver

You can connect up to 7 audio/video sources to this amplifier:

Source button	Corresponding connector
(receiver front panel)	(receiver back panel)
- DVD	DVD IN (audio / video)
- SAT	SAT IN (audio / video)
- VCR	VCR IN/OUT (audio / video)
- V-AUX	V-AUX IN (audio / video)
- CD	CD IN (audio only)
- TV	TV IN (audio only)
- TAPE	TAPE IN/OUT (audio only)
- FM/AM	built-in

When a source is selected, the source name will be shown on the display.

Example: Press DVD to select DVD as the source to the amplifier.

NOTE

1.Your receiver has a built in tuner. Just con- nect the appropriate antenna on the back of the receiver and you will be able to listen to radio stations. (See details in Tuner section)

2.Other sources can be connected to the above standard source. Example: you can con- nect a LD into the DVD inputs.

3.Refer to the "Connecting To Audio-Visual Components" section for details on connec- tion.

Using the Remote to Control Additional Components

You can set your remote to control other components (like CD, TV, DVD, TAPE, etc.). What you need is to encode them in advance (not necessary for recent RCA & Proscan models).

1.Turn on the component to be programmed.

2.Look up the brand and corresponding code num- ber in the code list from page 24 to 26.

3.Press and hold the corresponding Source Button (like VCR, TV, DVD) on the remote while entering the code from the code list using the Number Buttons.

4. Release the compo- nent button, then press ON•OFF to see if the component will turn off.

5. If this does not work,

repeat steps 3 and 4 by trying to use the next code (if available) listed for the brand of your component until the component responds to the remote com- mand.

14