RCA RT2350BK, RT2600 manual Advance Sound Control, Speaker Icons, Displaying Program Formats

Advance Sound Control

NOTE

•The sub-woofer selection will always be YES when the main speakers are set to small (SML).

•For the subwoofer phase setting, it will be affected by how you locate the subwoofer. Try both + and - settings and select the one that has better bass effect.

•If your unit comes with speakers, always set all speakers size to “small” to protect them and optimize the sound quality.

•When left and right front speakers are set to SMALL, center and surround speakers can not be set to LARGE.

Use a subwoofer to enjoy optimum sound.

•Subwoofer Phase: Try both settings and select the sound preferred.

•Speaker distance: For optimum surround experi- ence measure the distance between the speaker and your favorite listening position.

1. Press SETUP once.

SETUP TEST TONE EQ DIGITAL IN

OK

ST / MO

Speaker Icons

The receiver shows you the speakers’ types and set- tings on the display with the following icons:

L	R	Large front speakers
L	R	Small front speakers
	C	Large center speaker
	C	Small center speaker
LS	RS	Large rear speakers
LS RS		Small rear speakers
	LFE	Subwoofer present

Displaying Program Formats

When a digital source is playing, the receiver will automatically switch to the proper surround mode and indicates on the speaker icons on the right-hand side of the display. (See diagram)

L C R

LS LFE RS

2.While the VFD display is showing L/R SML, press UP/DOWN ARROW button to select.

MEMORY SETUP TEST TONE

OK

It is important to note, however, that not all Dolby Digital sources are encoded with the full complement of five channels plus LFE*. Speaker icons show how many and which speaker you have enabled (See “Fine Setting of the Speakers”) and the letters inside the speaker icons show which channel is present in the source information. For example, the diagram shown means you have all the five speakers and subwoofer enabled and the digital sources you played have five channels plus LFE complemented.

3.	Press OK button once to move to the next	* LFE stands for Low Frequency Effect. The indication
		“LFE” appears if the digital source contains LFE infor-
speaker setting.		mation. In this case, the bass signal will be delivered
4.	Repeat step 3 to set up the next speaker	to the subwoofer, offering more dynamic deep bass
		sound effects. If the letter is flashing, the signal is

either too weak or just gone.

5.When set up is done, wait for 5 seconds to

automatically save your
settings or press any key	SOURCE
	FM/AM	TUNIN
to save your selection	SOURCE
and set up mode.

22