Advanced Sound Control
Fine Setting of the Speakers
This receiver supports a wide range of speakers and subwoofers. For optimal surround sound enjoyment, you need to register the speaker selection settings of your audio system. If you buy this receiver with accompanied speaker package, then this step has been done for you.
Also, to make the surround sound more effective and suit the acoustic conditions in your listening room, you need to delay the signal from some of the speak- ers. Such channel delay compensates for center or surround speakers that are closer to listening position than the front speakers. You can make use of the SETUP button to adjust the speakers’ relative loud- ness.
The TEST TONE button
You can adjust the relative loudness of the individual speakers by the TEST TONE button.
4. Press LEVEL again to save your setting.
5. Repeat step 3 to adjust other speaker volume lev- EN els.
NOTE
To adjust the level of all speakers (center and surround speakers), you must select Pro Logic mode first by pressing the SURROUND key
Advanced Setting
Factory defaulted Advance setting indication from VFD
The receiver has defaulted the following distances:
1.In Surround (Dolby Digital/Pro Logic/DTS) modes, press TEST TONE briefly. A short noise will be heard in the speakers one by one. The speaker having the noise at that moment will be shown in the display.
S
SETUP TEST TONE EQ DIGITAL INPUT
OK
ST / MONO
Front
Left
Lch 
L/S
Rear
Left
Center
Front
Right
Cch |
| Front speakers | ||
|
|
| (L/R) | 15 ft |
|
| Rch |
| |
|
|
| Center speaker | |
|
|
| ||
|
|
| (Cch) | 15 ft |
|
| R/S |
| |
|
|
| ||
|
|
| Rear speaker | |
|
|
| (SUR) | 10 ft |
|
| Rear |
|
|
|
| Right |
|
|
2.To adjust the volume level of the test tone, turn up/down the VOLUME knob or press VOL UP/DOWN key on the remote control.
VOLUME
MODE
BASS/TREBLELEVEL
MODE
3.To adjust individual speaker volume level, press the LEVEL key on the main unit when the short noise is played on the speaker you want to adjust then turn the VOLUME knob to modify the output level.
BASS/TREBLELEVEL
Speaker Configurations
You can also change the setup of the speakers by pressing the SETUP button until the display shows L/R SML or L/R LRG which enables you to set the size of the front speaker.
Available Selections:
Front Speaker selection | Large/ Small |
Center Speaker selection | Large/ Small/ None |
Surround Speaker selection | Large/ Small/ None |
Subwoofer selection | Yes/ No |
Subwoofer Phase | + / - |
Front Speaker distance | |
Centre Speaker distance | |
Rear Speaker distance | |
|
|
Pressing SETUP button once, while the display is still showing L/R LRG, you may press the OK button to toggle among: front, center, surround, subwoofer, subwoofer phase and speakers’ distance, sleep and dimmer setup. Set the speaker size or speakers’ dis- tance by pressing UP/DOWN ARROW button.
21
