RCA RT2600, RT2350BK manual Unpacking The Speakers, Set up and Maintenance of the Receiver

Getting Started

Unpacking The Speakers

•one set of speakers including 2 front speakers, 1 centre speaker, 1 subwoofer and 2 rear speakers.

•6 speaker wires including:

Set up and Maintenance of the Receiver

EN

•Provide spaces for sufficient ventilation as indicated:

10 cm/4"

	H O M E	T H E A T E R A U D I O	V I D E O R E C E I V E R			VOLUME
10 cm/	ON/STANDBY							10 cm/
4"		SOURCE				SURR MODE		4"
	MUTE	FM/AM	TUNING	MEMORY	SETUP TEST TONE EQ DIGITAL INPUT	BASS/TREBLE	LEVEL
		SOURCE				DSP MODE

ST / MONO

1 X green/black wire for center speaker

1 X white/black wire for front left speaker

1 X blue/black wire for rear left speaker

1 X red/black wire for front right speaker

1 X purple/black wire for subwoofer

1 X gray/black wire for rear right speaker

PHONES	V-AUX	VIDEO	L - AUDIO - R
	10 cm/4"
5 cm/
2"

• Do not connect to the AC power cords until all

connections are completed.

• Do not use your set immediately after transferring

it from a cold place to a warm place: there is risk of

condensation.

• Do not expose your set to water and excessively

Inserting Batteries into Remote Control

Insert two AA(R6) batteries according to the + and - signs on the battery compartment. To use the remote control, point it directly at your receiver. Whenever a button is pressed, a red indicator will light up on the remote control.

Install batteries as follows:

1.Remove battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.

2.Insert 2 AA batteries in the compartment and replace the compartment door.

high temperatures.

• After having disconnected your set, clean the case

with a soft cloth, or with a slightly damp leather

chamois. Never use strong solvents.

Protect your Components from

Overheating

•Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.

•Do not stack components directly on top of each other.

•Allow adequate ventilation when placing your components in a stand.

•Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other com- ponents. If you have a satellite receiver, you should place it on the top shelf.

3