USB Device
An overview
This unit supports MSC devices. You can connect your own USB storage devices, then you can start playback.
Connecting/Disconnecting USB device to the Unit
Insert the USB drive's connector into the main unit’s USB jack of the unit. To disconnect, unplug the drive.
USB device playback features
1. Press USB to select USB mode.
2. Playback starts automatically. Press PAUSE EN to pause playback and press PLAY again
to resume.
3.Press STOP to end playback.
4.Press CH+/- buttons on the remote control to skip to the previous or next file.
5.You may also follow the playback instruction steps
Note: The unit only support mp3/
WMA/jpeg files on USB device.
Aux-In
TV, VCR or Set Top Box can be connected to AUX input jacks at the back of the unit so that sound from the auxiliary component comes into the unit and out through the speakers.
Connecting auxiliary components
Refer to page 3 “Connecting to external audio sources
Selecting Aux-In mode
Press either SOURCE on the main unit or AUX1/2 on the remote control to select AUX1 IN or AUX2 IN mode.
Sound output in Aux-In mode
•You may change the surround setting by pressing SURROUND to select between Dolby ProLogic and Stereo modes.
•If the auxiliary audio signal is mono (e.g. TV audio), there is no output from surround speakers in either Dolby ProLogic or Stereo mode.
•Refer to page 26 for details on Dolby Digital and Dolby ProLogic.
17