USING THE UNIVERSAL REMOTE CONTROL
PROGRAMMING THE REMOTE TO CONTROL A VCR
To determine whether you need to program the remote, turn on the VCR, point the remote at the VCR’s remote sensor, and press VCR. Then, press the POWER or CH + or CH – button to see if the VCR responds to the remote commands. If not, you need to program the remote.
Follow these steps to program your remote to control your VCR:
1.Turn on the VCR.
2.Look up your VCR brand and code number(s) in the code list on the next page or on the code sheet packed with your remote.
3.Press and hold the VCR button on the remote.
4.Enter the
5.Release the VCR button, then press POWER to see if the VCR responds to the remote commands. If not, try pressing VCR
then POWER.
6.Repeat steps 3 through 5 using the next code listed for your VCR brand until the VCR responds to the remote commands.
PROGRAMMING THE REMOTE TO CONTROL AN AUDIO COMPONENT
To program the remote for a
Follow these steps to program your remote to control your audio component:
1.Turn on the component to be programmed.
2.Look up the brand and corresponding code number in the code list on page 28 or on the code sheet packed with your remote.
3.Press and hold the component button on the remote.
4.Enter the
5.Release the component button, then press POWER to see if the component responds to the remote commands. If it doesn’t, try pressing the component button, then POWER again.
6.Repeat steps 3 through 5 using the next code listed for the brand of your component until the component responds to the remote commands.
PROGRAMMING THE REMOTE TO CONTROL A CABLE BOX
Refer to the cable box connection page or contact your cable company to hook up your cable box. You may be able to program the remote for your remote controllable cable box. Use the codes in the code list on page 28 or on the sheet packed with your remote.
1.Turn on the cable box.
2.Look up the cable box brand and its code number(s) in the code list on the next page or on the code sheet packed with the remote.
3.Press and hold the SAT•CABLE button on the remote.
4.Enter the
5.Release the SAT•CABLE button, then press POWER or CH + or CH – to see if the cable box responds to the remote commands. If not, try pressing SAT•CABLE, then POWER again to see if the cable box responds.
6.Repeat steps 3 through 5 using the next code listed for the brand of your cable box until the cable box responds to the remote commands.
PROGRAMMING THE REMOTE
TO CONTROL A LASERDISC PLAYER
You may be able to program your remote to control a laserdisc player. Use the codes shown to the right or on the sheet packed with your remote.
Follow these steps to program your remote to control your laserdisc player:
1.Turn on the laserdisc player.
2.Look up the brand and its code number(s) in the code list.
3.Press and hold the LD•VCR2 button on the remote.
4.Enter the
LASERDISC PLAYER CODES
Pioneer | 033, 037 |
ProScan | 033, 037 |
RCA | 033, 037 |
20
