RCA VPT 385 Programming the Timer, Checking the Timer Programs, Clearing a Timer Program, Your

Programming the Timer (continued)

f

151 The display will prompt you to select either	Press "1'" for AM or "2" for PM.
AM or PM.

ON C" J--I

[] NORM I

The display will prompt you to select the

[6]stopping time.

OFF	,,I/	AM	I"_ J..._[
	/1"	-- ,..CH	Jl,.,,,.I
]		NORM

171 The display will prompt you to select either AM or PM.

Press four digits, two for the hour and two more for the minute. For example, press 0 8 0 5 for 8:05. (Always press "0" before a single-digit hour or minute. The "0 +' will not appear in the display.)

Press "1" for AM or "2" for PM.

oFF LI" U_I ;or cH D4

]NORM

181 The display' will sho_ "START DATE" followed by the current date and day.

DATE SUN

,_,, lo o'l

J E!

] M NORM D

If you want to start recording on the current day. skip to Step 9.

If you want to start recording on a future date, press four digits (two for the month and two for the day). Press "0" first for a single- digit month or day. For example, press 0 7 0 9 to begin recording on July 9.

The year and day of the week are displayed automatically when you finish.

19] Press	PROGRAM	to enter	your	program and	[110] Turn off the VCR. (See "Programming Reminders'"
return to the clock display. Additional programs					1 on page 26.)
rmay	be entered by	repeating	steps	2-9.

-Checking the Timer Programs

Programs can be checked whenever the VCR is turned

on.

I. Press PROGRAM on the remote hand unit to display the programming menu.

2.Press 5 (Program Review).

The display will show the START TIME, STOP TIME and START DATE you entered for the lowest program number at four-second intervals. Then the display changes to the next higher program number, and so on until all program information has been displayed.

3.Press 5 again if you wanl to view the next infor- mation without waiting four seconds.

4.When you are finished, press PROGRAM to return to the clock display.

-Clearing a Timer Program

1.Press PROGRAM on the remote hand unit to display the programming menu.

2.Press 5 (Program Review).

The display will show the START TIME, STOP TIME and START DATE you entered for the lowest program number at four-second intervals. Then the display changes to the next higher program number, and so on until all program information has been displayed.

3.Press 5 again if you want to view the next infor- mation withoul waiting four seconds.

4.Press CLEAR when the program information you want to clear is displayed.

Notes:

•Normal timer programs clear automatically when the recording is finished, but daily and weekly programs remain in the timer indefinitely.

•All programs are erased if power is interrupted for more than approximately ten minutes.

25