RCA VR618HF manual Turn on the TV, Turn on the VCR, Place channels in the VCR’s memory, Startup

Setting Up the VCR

Startup

4.Turn on the TV.

A.Turn on the TV.

B. If you used one of the basic hookups, tune the TV to the channel selected with the CH3 CH4 switch on back of VCR.

If you used one of the advanced hookups, tune the TV to the TVÕs video input. (See TV ownerÕs manual for details.)

5.Turn on the VCR.

A.Press VCR on the remote.

6.Place channels in the VCR’s memory.

The first time you turn on the VCR or after a power interruption, the VCR will display a message on the TV screen prompting you to Auto-Search Channels for the VCR. If the message does not appear, go to step A below. If the message appears, follow the directions on the screen.

Wait until the channel numbers stop changing. This takes about one to two minutes. The TV will then tune to the lowest channel found. Pressing CHANNEL up or down will select only the active channels.

If you ever need to manually Auto-Search Channels because you change cable or antenna signals:

A. Press MENU to display the VCR MAIN MENU on the TV screen. If this menu does not appear:

¥Make sure TV is tuned to same channel as the CH3 CH4 switch on the back of the VCR or the TVÕs video input (refer to TVÕs manual).

¥Press VCR, then press MENU again.

¥If you use a basic hookup, check VCR indicator in display panel Ð it should be on. Press TV•VCR to turn it on.

¥Check the connections.

B. Press 4 to display the CHANNELS menu.

C. Press 1 to begin Auto Channel Search.

The VCR automatically selects CABLE (cable TV) or ANTENNA. If you need to change the setting manually, press 3.

Auto-Search Channels

Connect antenna cable...

then press CH UP.

VCR MAIN MENU

1 VCR Plus+

2 Timer Recordings

3 Set Clock

4 Channels

CHANNELS

1 Auto Channel Search

2 Add/Remove Channels

3 Signal Type: CABLE

4 VCR Plus+ Channel List

0 Exit

8